Slide the jack under the strut and jack the car up until the stock spring is compressed, then install the coil spring compressor on the spring. Remove the lug nuts, pull the wheel off of the hub, and use the socket set to remove the nut from the top mounting bolt of the strut tower. Use the pickle fork tool to remove the ball joint and control arm from the strut and pull the strut tower out from under the car. Slide the compressed spring off of the strut tower. Install the new coil springs on the strut tower and then slide the tower back into place. Tighten down the mounting bolt on top of the tower and remount the ball joint. Mount the wheel and lower the car to the ground.